1 Operational Manual
G) HHHHHH: Display the total no..(= Bad product no.+ Good product no.)
H) CC.C: In auto mode, set the range of failure rate.
I) II.I: Display the failure rate.
J) DDDDD: Set the total numbers, the program counter is
“
CNT4
”
.
K) JJJJJ: Display the total product numbers.
L) NNNNNNNN: Function selection for total product numbers. Press
or to
select
“
discount
”
or
“
count
”
, then press
to complete a correction.
M) EEEEE : Set bad product numbers, the program counter is
“
CNT 16
”
.(optional)
N) KKKKK: Display the bad product numbers.
O) OOOOOOOO: Function selection for bad product numbers. Press
or to
select
“
discount
”
or
“
count
”
, then press to complete a correction.
P) PPPPP: Display
“
Hours
”
of operational time.
Q) QQ: Display
“
Minutes
”
of operational time.
R) RRRR: Display
“
Hours
”
of auto operational time.
S) SS: Display
“
Minutes
”
of auto operational time.
T) Applied to bad product counting:
In menu (43), “LLLLLL” select as a counter mode.
U) Applied to bad product counting:
In menu (43), “LLLLLL” select as a counter mode.
V) Applied to total product counting:
In menu (43) “LLLLLL” select as a counter mode, next move cursor to select “NNNNNN” as a
counter mode too. When the good product number is reached the setting value, then the
accumulator will add 1, and when accumulator is reached the setting value. The alarm 041
product reached setting value is beginning to stop machine operation for one cycle operation.
04/08/13
94
To Next Page
Loading...
