Chen Hsong CDC-2000 - 049 The Sensor of Electronic Eye Is Covered

1 Operational Manual
TIMER SETTING
TIMER SET (SEC)
CYCLE TIME ••••••••••••••••••
AAAA.A
INTERMISSION •••••••••••••••••
BBBB.B
ALARM OF FEEDING DURING MOLD OPENING •••••
CCCC.C
ALARM OF ACCUMLATOR PRESSURIZED••••••••
DDDD.D
DEFECT OUTPUT TIME ALARM •••••••••••
EEEE.E
SPARE•••••••••••••••••••••
FFFF.F
SPARE•••••••••••••••••••••
GGGG.G
EJECT-OUT PAUSE••••••••••••••••
HHHH.H
PNEUMATIC EJECTOR FORWARD STROKE •••••••
IIII.I
PNEUMATIC EJECTOR BACKWARD STROKE•••••••
JJJJ.J
EMTRUSION ••••••••••••••••••
KKK.KK
LLLL.L
MMMM.M
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
Menu35
3.32 “049 The Sensor of Electronic Eye is Covered”
(A) In menu 32 pick product
“
choose
“
open, in auto mode if sensor detect that material
is not totally dropped then alarm will sound.
(B) Remedy:
a) Please check and remove the product that is stuck at the side.
b) Check photocell and circuit (input 11).
3.33 “050 The Clamping Distance Has Stopped”
(A) When press mold-close key, at the end of the mold-closing, this message will
comes out.
04/08/13
175