1 Operational Manual
O) AAAAAAAAAAAAA: Auto shut-off function. Either press or to make
a pick among following four modes, and push
to complete the selection.
Code descriptions for function selections are as follows:
L.a) Auto shut-off function off.
L.b) Hydraulic pump off: This is applied when abnormal conditions occur.
L.c) Heater Off: Heater off when abnormal conditions occur.
L.d) Hydraulic Pump and Heater Off: Both hydraulic pump and heater should be
off during abnormal conditions.
2.40.2 Function Selection Setup for High-Pressure Cylinder
FUNCTION SETTING MODE
FUNCTION SETTING SELECT
PHOTO CELL FUNCTION••••••••••••••
ＢＢＢ
ACCUMLATOR INJECTION •••••••••••••
ＣＣＣ
HYDRAULIC MOLD CLAMPER ••••••••••••
ＤＤＤ
THERMOSET MOLD HIGH-PRESSURE DEGAS ••••••
ＥＥＥ
THERMOSET MOLD OPEN DEGAS•••••••••••
ＦＦＦ
AUTO. MOLD EXCHANGE••••••••••••••
ＧＧＧ
MULTI MOLD OPENING FUNCTION •••••••••
ＨＨＨ
EXTRUSION•••••••••••••••••••
ＩＩＩ
SPARE 2 •••••••••••••••••••
ＪＪＪ
SPARE 3 •••••••••••••••••••
ＫＫＫ
SPARE 4 •••••••••••••••••••
ＬＬＬ
AUTOMATIC SHUT-OFF FUNCTION••••••••••
AAAAAAAAAAAAA
F1 F2 F3
F4 F5
F6
F7
F8
F9 F10
Menu 32
Move cursor to set parameter. Push to “open” or to “close”and push to complete
a correction. Code descriptions for menu 32 is as follows:
A) BBB: Photo-cell function
B) CCC: Spare
04/08/13
130
To Next Page
Loading...
