1 Operational Manual
AA) AAAAAAAAAAAAA: Auto shut-off function. Either press or to make
a pick among following four modes, and push
to complete the selection.
Code descriptions for function selections are as follows:
L.a) Auto shut-off function off.
L.b) Hydraulic pump off: This is applied when abnormal conditions occur.
L.c) Heater Off: Heater off when abnormal conditions occur.
L.d) Hydraulic Pump and heater Off: Both hydraulic pump and heater are off
during abnormal conditions.
2.40.4 Function Selection Setup for Combined Cylinder
FUNCTION SETTING MODE
FUNCTION SETTING SELECT
PHOTO CELL FUNCTION••••••••••••••
ＢＢＢ
ACCUMLATOR INJECTION •••••••••••••
ＣＣＣ
HYDRAULIC MOLD CLAMPER ••••••••••••
ＤＤＤ
THERMOSET MOLD HIGH-PRESSURE DEGAS ••••••
ＥＥＥ
THERMOSET MOLD OPEN DEGAS•••••••••••
ＦＦＦ
AUTO. MOLD EXCHANGE••••••••••••••
ＧＧＧ
MULTI MOLD OPENING FUNCTION •••••••••
ＨＨＨ
EXTRUSION•••••••••••••••••••
ＩＩＩ
SPARE 2 •••••••••••••••••••
ＪＪＪ
SPARE 3 •••••••••••••••••••
ＫＫＫ
SPARE 4 •••••••••••••••••••
ＬＬＬ
AUTOMATIC SHUT-OFF FUNCTION••••••••••
AAAAAAAAAAAAA
F1 F2 F3
F4 F5
F6
F7
F8
F9 F10
Menu 32
Move cursor to set parameter. Press to “open” or to “clear” and push to complete
a correction. Code descriptions for menu 32 is as follows:
BB) BBB: Photo-cell function
CC) CCC: Spare
DD) DDD: Spare
04/08/13
133
To Next Page
Loading...
