HIPOT Tester 19051/19052/19053/19054 User’s Manual
Description: This command means GFI function is set to OFF.
[: SWITCH]?
: SOURce: SAFEty: PRESet: GFI: SWITCH?
This command queries GFI switch is ON or OFF.
Return 1 or 0 (0 means GFI is OFF, 1 means GFI is ON).
Example: Input command “SAFE: PRES: GFI?”
Return message “0”
Description: Return message “0” means GFI function is OFF.
: FAIL
:OPERation STOP|CONTinue|RESTart
: SOURce: SAFEty: PRESet: FAIL: OPERation
This command sets AFTER FAIL parameter of PRESET.
Parameter STOP is to stop the test.
Parameter CONTinue is to continue the test.
Parameter RESTart is FAIL occurred then press START to retest.
Example: Input command “SAFE: PRES: FAIL: OPER CONT”
Description: This command means the function of AFTER FAIL is set to
CONTINUE.
:OPERation?
This command queries the setting status of AFTER FAIL.
Response value is the same as setting value is STOP or CONTINUE or
RESTART.
Example: Input command “SAFE: PRES: FAIL: OPER?”
Return message “CONTINUE”
Description: Return message “CONTINUE” means the setting status of
AFTER FAIL is CONTINUE.
:SCREen <Boolean>|ON|OFF
: SOURce: SAFEty: PRESet: SCREen
This command sets if display test screen.
Example: Input command SAFE: PRES: SCRE ON
Description: This command means if display the function of test screen is
set to ON.
:SCREen ?
: SOURce: SAFEty: PRESet: SCREen?
This command queries if display test screen.
Example: Input command “SAFE: PRES: SCRE?”
Return message “1”
Description: Return message “1” means test screen is displayed.
: KEYboard
:SMARt <Boolean>|ON|OFF
: SOURce: SAFEty: PRESet: KEYboard: SMARt
This command sets if SMART KEY is ON or OFF.
Example: Input command “SAFE: PRES: KEY: SMAR ON”
Description: This command means the function of SMART KEY is
set to ON.
:SMARt?
: SOURce: SAFEty: PRESet: KEYboard: SMARt?
5-36
www.valuetronics.com
To Next Page
Loading...
