3. Pull the floor panel and position it toward the front
seats while folding the top half down and rest it
against the front seats.
4. Pull the strap located on the seat and pull the seat
out of the storage area. Push the seat rearward
making sure that it locks into the floor. Fold the
seatback into the upright position and pull the head-
rest up.
NOTE:
If the seatback is locked, it will be necessary to use
the recliner handle to unlock the back before folding
into the upright position.
5. Replace the plastic storage bin into the storage
area.
6. To position the floor panel back into its original
state, grab the bottom corner and extend it outward.
7. Lay the floor panel flat and push down until it clicks
into position.
8. Readjust the front seat as needed, and replace the
floor mat (if equipped).
WARNING!
•
In a collision, you or others in your vehicle could be
injured if seats are not properly latched to their
floor attachments. Always be sure the seats are
fully latched.
•
Sitting in a seat with the head restraint in its low-
ered position could result in serious injury or death
in a collision. Always make sure the head
restraints are in their upright positions when the
seat is to be occupied.
Push Panel Forward
Pull Strap
Extend Panel
Push Down To Lock
48 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
