7. Close the floor by pulling the floor panel backwards
by the bottom corner edge of the panel.
8. Push down on floor panel to lock into place.
9. Readjust the front seat as needed, and replace the
floor mat (if equipped).
WARNING!
In a collision, serious injury could result if the seat
storage bin covers are not properly latched:
•
Do not drive the vehicle with the storage bin covers
open.
•
Keep the storage bin covers closed and latched
while the vehicle is in motion.
•
Do not use a storage bin latch as a tie down.
CAUTION!
•
The storage bin cover must be latched and flat to
avoid damage from contact with the front seat
tracks, which have minimal clearance to the cover.
•
Do not sit on the second row seat when it is in the
stowed position with the seatback upright other-
wise damage to the seat may occur.
TO UNSTOW SECOND ROW SEATS
For Manual Seats: To unstow the seat from the floor,
move the front seat all the way forward using the
manual seat adjustment bar.
For Power Seats: Push the Auto Advance ‘n Return but-
ton located on the B-pillar trim (if equipped)
page 45.
1. To access the storage area, remove the floor mat
(if equipped) and place the lock rod in the unlocked
position.
NOTE:
○
Push the lock rod inward for the unlocked position.
○
Pull outward on the lock rod for the locked position.
2. Pull the latch located near the second row seat to
open the floor panel.
Extend Floor Panel
Push To Lock
Lock Rod
Floor Latch
GETTING TO KNOW YOUR VEHICLE 47
2
To Next Page
Loading...
