Rear Defrost Button
Press and release the Rear Defrost Control
button on the touchscreen or push and
release the button on the faceplate to turn
on the rear window defroster and the heated
outside mirrors (if equipped). An indicator will illuminate
when the rear window defroster is on. The rear window
defroster automatically turns off after 15 minutes.
CAUTION!
Failure to follow these cautions can cause damage to
the heating elements:
•
Use care when washing the inside of the rear win-
dow. Do not use abrasive window cleaners on the
interior surface of the window. Use a soft cloth and
a mild washing solution, wiping parallel to the
heating elements. Labels can be peeled off after
soaking with warm water.
•
Do not use scrapers, sharp instruments, or abra-
sive window cleaners on the interior surface of the
window.
•
Keep all objects a safe distance from the window.
Front Temperature Control
These buttons provide the driver and passenger with
independent temperature control.
Push the red button on the faceplate or
touchscreen or press and slide the tempera-
ture bar towards the red arrow button on the
touchscreen for warmer temperature
settings.
Push the blue button on the faceplate or
touchscreen or press and slide the tempera-
ture bar towards the blue arrow button on
the touchscreen for cooler temperature
settings.
NOTE:
The temperature can also be adjusted by pressing the
Temperature readout on the top left and right corners
of the status bar.
SYNC Button
Press the SYNC button on the touchscreen
to toggle the SYNC feature on/off. The SYNC
indicator is illuminated when this feature is
enabled. SYNC is used to synchronize the
front and rear passenger temperature settings with the
driver temperature setting. Changing the front or rear
passenger temperature setting while in SYNC will auto-
matically exit this feature.
NOTE:
The SYNC setting is only available on the touchscreen.
Blower Control
Blower Control regulates the amount of air
forced through the climate control system.
There are seven blower speeds available.
Adjusting the blower will cause automatic
mode to switch to manual operation. The speeds can
be selected using either the blower control knob on the
faceplate or the buttons on the touchscreen.
•
Faceplate: The blower speed increases as you turn
the blower control knob clockwise from the lowest
blower setting. The blower speed decreases as you
turn the blower control knob counterclockwise.
•
Touchscreen: Blower speed can be selected by
pressing the blower bar area between the icons.
Press the desired blower speed from 1-7.
Mode Control
The airflow distribution mode can be
adjusted so air comes from the instrument
panel outlets, floor outlets, defrost outlets
and demist outlets.
Faceplate: Push the button in the center of the knob to
change the airflow distribution mode.
Touchscreen: Select Mode by pressing one of the Mode
Buttons on the touchscreen.
Panel Mode
Air comes from the outlets in the instrument
panel. Each of these outlets can be individu-
ally adjusted to direct the flow of air. The air
vanes of the center outlets and outboard
outlets can be moved up and down or side to side to
regulate airflow direction. There is a shut-off wheel
located below the air vanes to shut off or adjust the
amount of airflow from these outlets.
Bi-Level Mode
Air comes from the instrument panel outlets
and floor outlets. A slight amount of air is
directed through the defrost and side win-
dow demister outlets.
NOTE:
Bi-Level mode is designed under comfort conditions to
provide cooler air out of the panel outlets and warmer
air from the floor outlets.
GETTING TO KNOW YOUR VEHICLE 69
2
To Next Page
Loading...
