Need help?Do you have a question about the Cimarron ARCONTROL BMS and is the answer not in the manual?
General| Enclosure | Plastic |
|---|---|
| Mounting | DIN rail |
| Protection Rating | IP20 |
| Communication Protocol | BACnet MS/TP |
| Input Voltage | 24 VAC |
| Processor | ARM Cortex-M |
| Memory | 512 KB Flash |
General instructions regarding safety, wiring, and materials for ARControl BMS installation.
Details on the intended use of the BMS Module's valve output and thermocouple input.
Guidelines for electrical codes, grounding, and mounting hardware for ARControl.
Step-by-step instructions for installing the ARControl BMS unit and related components.
Information on power requirements and supply types for the ARControl.
Accessing diagnostic information and enabling diagnostic mode for testing.
Procedure for navigating menus and changing system settings.
Adjusting ignition timing, modes, pilot on demand, and temperature limits.
Configuration of SOURCE, LOGIC, HIGH LEVEL, LOW LEVEL, CEILING, and FLOOR for processes.
Setting PID parameters like SOURCE, SETPOINT, P, I, D GAIN, and DEADBAND.
Configuring SHUTDOWN settings (SOURCE, LOGIC, HIGH LEVEL, LOW LEVEL).
Adjusting OFFSET TC1, OFFSET TC2, and UNITS for thermocouple calibration.
Configuring ALARM, XDCR TYPE, PERMISSIVE, PS1, PS2, and PS3 modes.
Setting ADDRESS, BAUDRATE, and WORD ORDER for Modbus communication.
Explains operation in AUTOMATIC mode, including ignition and process control.
Explains operation in MANUAL mode, including user-controlled ignition and process control.
Conditions that trigger alarms and stop system processes.
Steps and equations for calculating SPAN for transducer calibration.
Troubleshooting steps for system ignition failures.
Troubleshooting steps for when the system fails to detect flame.
To Next Page
