2-92
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
dot1x timeout
This example shows how to set 60 as the number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before retransmitting the request:
Switch(config-if)# dot1x timeout tx-period 60
Switch(config-if)#
You can verify your settings by entering the show dot1x privileged EXEC command.
Related Commands dot1x initialize
show dot1x
To Next Page
Loading...
