EasyManuals Logo

Cisco 4500M Command Reference

Cisco 4500M
578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #308 background imageLoading...
Page #308 background image
2-276
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
show interfaces capabilities
show interfaces capabilities
To display the interface capabilities for an interface or for all the interfaces on a switch, use the show
interfaces capabilities command.
show interfaces capabilities [{module mod}]
show interfaces [interface interface-number] capabilities
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC
Command History
Usage Guidelines The interface-number variable designates the module and port number. Valid values for
interface-number depend on the chassis and module used. For example, if you have a 48-port
10/100-Mbps Fast Ethernet RJ-21 (telco connector) switching module installed in a Catalyst 4507
chassis, valid values for the slot number are from 2 to 13 and valid values for the port number are 1 to 48.
Examples This example shows how to display interface capabilities for a module:
Router# show interfaces capabilities module 1
GigabitEthernet1/1
Model: WS-X4516-Gbic
Type: Unsupported GBIC
Speed: 1000
Duplex: full
Trunk encap. type: 802.1Q,ISL
Trunk mode: on,off,desirable,nonegotiate
Channel: yes
Broadcast suppression:percentage(0-100), hw
Flowcontrol: rx-(off,on,desired),tx-(off,on,desired)
VLAN Membership: static, dynamic
Fast Start: yes
Queuing: rx-(N/A), tx-(4q1t, Sharing/Shaping)
CoS rewrite: yes
ToS rewrite: yes
module mod (Optional) Keyword and variable to display information for the specified
module only.
interface (Optional) Specifies the interface type. Valid values are fastethernet,
gigabitethernet, and port-channel.
interface-number (Optional) Specifies the port number.
Release Modification
12.1(19)EW Support for this command was introduced on the Catalyst 4500 series
switch.

Table of Contents

Other manuals for Cisco 4500M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 4500M and is the answer not in the manual?

Cisco 4500M Specifications

General IconGeneral
BrandCisco
Model4500M
CategoryNetwork Router
LanguageEnglish

Related product manuals