2-189
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
pagp port-priority
pagp port-priority
To select a port in hot standby mode, use the pagp port-priority command. To return to the default
value, use the no form of this command.
pagp port-priority priority
no pagp port-priority
Syntax Description
Defaults Port priority is set to 128.
Command Modes Interface configuration
Command History
Usage Guidelines The higher the priority, the better the chances are that the port will be selected in the hot standby mode.
Examples This example shows how to set the port priority:
Switch(config-if)# pagp port-priority 45
Switch(config-if)#
Related Commands pagp learn-method
show pagp
priority Port priority number; valid values are from 1 to 255.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
To Next Page
Loading...
Need help?
General
