EasyManuals Logo

Cisco 4500M Command Reference

Cisco 4500M
578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
1-5
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter1 Command-Line Interface
Understanding Command Modes
When you start a session on the Catalyst4500 series switch, you begin in user mode, often called EXEC
mode. Only a limited subset of the commands are available in EXEC mode. In order to have access to
all commands, you must enter privileged EXEC mode. Normally, you must enter a password to enter
privileged EXEC mode. From privileged EXEC mode, you can enter any EXEC command or enter global
configuration mode. Most EXEC commands are one-time commands, such as show commands, which
show the current status of a given item, and clear commands, which clear counters or interfaces. The
EXEC commands are not saved across reboots of the Catalyst4500 series switch.
The configuration modes provide a way for you to make changes to the running configuration. When you
save changes to the configuration, the changes remain intact when the Catalyst 4500 series switch
reboots. From global configuration mode, you can enter interface configuration mode, subinterface
configuration mode, and other protocol-specific modes.
ROM-monitor mode is a separate mode used when the Catalyst4500 series switch cannot boot properly.
If your Catalyst4500 series switch or access server does not find a valid system image when it is booting,
or if its configuration file is corrupted at startup, the system might enter ROM-monitor mode.
Table1-3 provides a summary of the main command modes.
Table1-3 Summary of Main Command Modes
Command
Mode Access Method Prompt Exit Method
User EXEC Log in. Switch> Use the logout command.
Privileged
EXEC
From user EXEC mode,
enter the enable EXEC
command.
Switch# To exit to user EXEC mode, enter the disable
command.
To enter global configuration mode, enter the
configure terminal privileged EXEC command.
Global
configuration
From privileged EXEC
mode, enter the
configure terminal
privileged EXEC
command.
Switch(config)# To exit to privileged EXEC mode, enter the exit or
end command or press Ctrl-Z.
To enter interface configuration mode, enter an
interface configuration command.
Interface
configuration
From global
configuration mode,
enter by specifying an
interface with an
interface command.
Switch(config-if)# To exit to global configuration mode, enter the exit
command.
To exit to privileged EXEC mode, enter the exit
command or press Ctrl-Z.
To enter subinterface configuration mode, specify a
subinterface with the interface command.

Table of Contents

Other manuals for Cisco 4500M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 4500M and is the answer not in the manual?

Cisco 4500M Specifications

General IconGeneral
BrandCisco
Model4500M
CategoryNetwork Router
LanguageEnglish

Related product manuals