2-451
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
speed
speed
To configure the interface speed, use the speed command. To disable a speed setting, use the no form of
this command.
speed [10 | 100 | 1000 | auto | nonegotiate]
no speed
Syntax Description
Defaults The default values are shown in the following table:
Command Modes Interface configuration
Command History
Usage Guidelines Table2-22 lists the supported command options by interface.
10 (Optional) Configures the interface to transmit at 10 Mbps.
100 (Optional) Configures the interface to transmit at 100 Mbps.
1000 (Optional) Configures the interface to transmit at 1000 Mbps.
auto (Optional) Enables the interface to auto-negotiate the speed.
nonegotiate (Optional) Enables the interface to not negotiate the speed.
Interface Type Supported Syntax Default Setting
10/100-Mbps module speed [10 | 100 | auto] Auto
100-Mbps fiber modules Not applicable Not applicable
Gigabit Ethernet Interface speed nonegotiate Nonegotiate
10/100/1000 speed [10 | 100 | 1000 | auto] Auto
1000 Not applicable Not applicable
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.