EasyManua.ls Logo

Cisco 4500M

Cisco 4500M
578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-241
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
show auto qos
show auto qos
To display the automatic quality of service (auto-QoS) configuration that is applied, use the show auto
qos user EXEC command.
show auto qos [interface [interface-id]] [{begin | exclude | include} expression]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines The show auto qos interface interface-id command displays the auto-QoS configuration; it does not
display any user changes to the configuration that might be in effect.
To display information about the QoS configuration that might be affected by auto-QoS, use one of these
commands:
show qos
show qos map
show qos interface interface-id
show running-config
Expressions are case sensitive. For example, if you enter exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
interface interface-id (Optional) Displays auto-QoS information for the specified interface or
for all interfaces. Valid interfaces include physical ports.
begin (Optional) Begins with the line that matches the expression.
exclude (Optional) Excludes lines that match the expression.
include (Optional) Includes lines that match the specified expression.
expression (Optional) Expression in the output to use as a reference point.
Release Modification
12.1(19)EW Support for this command was introduced on the Catalyst 4500 series switch.

Table of Contents

Other manuals for Cisco 4500M

Related product manuals