Cisco 4500M Command Reference

2-202
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
power supplies required
power supplies required
To configure the power redundancy mode for the Catalyst 4006 (only), use the power supplies required
command. To return to the default power redundancy mode, use the default form of this command or
the power supplies required 2 command.
power supplies required {1 | 2}
default power supplies required
Syntax Description
Defaults 2+1 redundancy mode
Command Modes Global configuration
Command History
Usage Guidelines This command is not supported on a Catalyst4500 series switch.
Examples This example shows how to set the power supplies required for the chassis to 1:
Switch(config)# power supplies required 1
Switch(config)#
Related Commands show power
1 Configures the chassis for 1+1 redundancy mode.
2 Configures the switch to 2+1 redundancy mode.
Release Modification
12.1(11)EW Support for this command was introduced on the Catalyst 4500 series switch
(Catalyst 4006 only).

Cisco 4500M Specifications

General

Brand	Cisco
Model	4500M
Category	Network Router
Language	English