Cisco 4500M Command Reference

2-162
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
lacp system-priority
lacp system-priority
To set the priority of the system for LACP, use the lacp system-priority command.
lacp system-priority priority
Syntax Description
Defaults Priority is set to 32768.
Command Modes Global configuration mode
Command History
Usage Guidelines This command is not supported on systems configured with a Supervisor Engine 1.
You must assign each switch running LACP a system priority that can be specified automatically or by
entering the lacp system-priority command. The system priority is used with the switch MAC address
to form the system ID and is also used during negotiation with other systems.
Although this command is a global configuration command, the priority value is supported on port
channels with LACP-enabled physical interfaces.
When setting the priority, the higher the number, the lower the priority.
You can also enter the lacp system-priority command in interface configuration mode. After you enter
the command, the system defaults to global configuration mode.
Examples This example shows how to set the system priority:
Switch(config)# lacp system-priority 23748
Switch(config)#
Related Commands channel-group
channel-protocol
lacp port-priority
show lacp
priority Priority of the system; valid values are from 1 to 65535.
Release Modification
12.1(13)EW This command was introduced on the Catalyst4500 series switches.

Cisco 4500M Specifications

General

Brand	Cisco
Model	4500M
Category	Network Router
Language	English