Name: Cisco 4500M
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

2-415

Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW

78-16201-01

Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches

snmp-server enable traps

To enable SNMP notifications (traps or informs), use the snmp-server enable traps command. To

disable all SNMP notifications, use the no form of this command.

snmp-server enable traps [flash [insertion | removal] | fru-ctrl |

no snmp-server enable traps flash [insertion | removal] | fru-ctrl | port-security

Syntax Description

Defaults SNMP notifications are disabled.

Command Modes Global configuration

Command History

Usage Guidelines If you enter this command without an option, all notification types controlled by this command are

enabled.

SNMP notifications can be sent as traps or inform requests. This command enables both traps and inform

requests for the specified notification types. To specify whether the notifications should be sent as traps

or informs, use the snmp-server host [traps | informs] command.

The snmp-server enable traps command is used in conjunction with the snmp-server host command.

Use the snmp-server host command to specify which host or hosts receive SNMP notifications. To send

notifications, you must configure at least one snmp-server host command.

flash (Optional) Controls the SNMP FLASH trap notifications.

insertion (Optional) Controls the SNMP Flash insertion trap notifications.

removal (Optional) Controls the SNMP Flash removal trap notifications.

fru-ctrl (Optional) Controls the SNMP entity FRU control trap notifications.

port-security (Optional) Controls the SNMP trap generation.

trap-rate trap-rate (Optional) Sets the number of traps per second.

stpx (Optional) Controls all the traps defined in

CISCO-STP-EXTENSIONS-MIB notifications.

vlancreate (Optional) Controls the SNMP VLAN created trap notifications.

vlandelete (Optional) Controls the SNMP VLAN deleted trap notifications.

vtp (Optional) Controls the SNMP VTP trap notifications.

Release Modification

12.1(13)EW Support for this command was introduced on the Catalyst 4500 series switch.

Cisco 4500M Command Reference

Other manuals for Cisco 4500M