Cisco 4500M

2-416
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
snmp-server enable traps
The following is a list of the MIBs used for the traps:
• flash—Controls SNMP FLASH traps from the CISCO-FLASH-MIB.
– insertion—Controls the SNMP Flash insertion trap notifications.
– removal—Controls the SNMP Flash removal trap notifications.
• fru-ctrl—Controls the FRU control traps from the CISCO-ENTITY-FRU-CONTROL-MIB.
• port-security—Controls the port-security traps from the CISCO-PORT-SECURITY-MIB.
• stpx—Controls all the traps from the CISCO-STP-EXTENSIONS-MIB.
• vlancreate—Controls SNMP VLAN created trap notifications.
• vlandelete—Controls SNMP VLAN deleted trap notifications.
• vtp—Controls the VTP traps from the CISCO-VTP-MIB.
Examples This example shows how to send all traps to the host specified by the name myhost.cisco.com, using the
community string defined as public:
Switch(config)# snmp-server enable traps
Switch(config)# snmp-server host myhost.cisco.com public
Switch(config)#
Related Commands Refer to Cisco IOS documentation for additional snmp-server enable traps commands.