EasyManuals Logo

Cisco 4500M Command Reference

Cisco 4500M
578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #351 background imageLoading...
Page #351 background image
2-319
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
show ip mroute
show ip mroute
To display IP multicast routing table information, use the show ip mroute command.
show ip mroute [interface_type slot/port | host_name | host_address [source] | active [kbps |
interface_type num] | count | pruned | static | summary]
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC
Command History
Usage Guidelines If you omit all optional arguments and keywords, the show ip mroute command displays all entries in
the IP multicast routing table.
The show ip mroute active kbps command displays all sources sending at a rate greater than or equal
to kbps.
The multicast routing table is populated by creating source, group (S,G) entries from star, group (*,G)
entries. The star refers to all source addresses, the “S” refers to a single source address, and the “G” is
the destination multicast group address. In creating (S,G) entries, the software uses the best path to that
destination group found in the unicast routing table (that is, through Reverse Path Forwarding (RPF).
interface_type
slot/port
(Optional) Interface type and number of the slot and port; valid values for
interface type are FastEthernet, GigabitEthernet, null, and vlan.
host_name (Optional) Name or IP address as defined in the DNS hosts table.
host_address
source
(Optional) IP address or name of a multicast source.
active (Optional) Displays the rate that active sources are sending to multicast groups.
kbps
interface_type num
(Optional) Minimum rate at which active sources are sending to multicast
groups; active sources sending at this rate or greater will be displayed. Valid
values are from 1 to 4294967295 kbps.
count (Optional) Displays route and packet count information.
pruned (Optional) Displays pruned routes.
static (Optional) Displays static multicast routes.
summary (Optional) Displays a one-line, abbreviated summary of each entry in the IP
multicast routing table.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.

Table of Contents

Other manuals for Cisco 4500M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 4500M and is the answer not in the manual?

Cisco 4500M Specifications

General IconGeneral
BrandCisco
Model4500M
CategoryNetwork Router
LanguageEnglish

Related product manuals