2-420
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
spanning-tree bpdufilter
spanning-tree bpdufilter
To enable BPDU filtering on an interface, use the spanning-tree bpdufilter command. To return to the
default settings, use the no form of this command.
spanning-tree bpdufilter {enable | disable}
no spanning-tree bpdufilter
Syntax Description
Defaults Disabled
Command Modes Interface configuration
Command History
Usage Guidelines
Caution Use care when entering the spanning-tree bpdufilter enable command. Enabling BPDU filtering on an
interface is approximately equivalent to disabling the spanning tree for this interface. It is possible to
create bridging loops if this command is not correctly used.
When configuring Layer 2 protocol tunneling on all the service provider edge switches, you must enable
spanning tree BPDU filtering on the 802.1Q tunnel ports by entering the spanning-tree bpdufilter
enable command.
BPDU filtering allows you to prevent a port from sending and receiving BPDUs. The configuration is
applicable to the whole interface, whether it is trunking or not. This command has three states:
• spanning-tree bpdufilter enable—This state unconditionally enables the BPDU filter feature on
the interface.
• spanning-tree bpdufilter disable—This state unconditionally disables the BPDU filter feature on
the interface.
• no spanning-tree bpdufilter—This state enables the BPDU filter feature on the interface if the
interface is in operational PortFast state and if the spanning-tree portfast bpdufilter default
command is configured.
enable Enables BPDU filtering on this interface.
disable Disables BPDU filtering on this interface.
Release Modification
12.1(12c)EW Support for this command was introduced on the Catalyst 4500 series switch.
To Next Page
Loading...
Need help?
General
