Cisco 4500M

2-335
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
show mac access-group interface
show mac access-group interface
To display the ACL configuration on a Layer 2 interface, use the show mac access-group interface
command.
show mac access-group interface [interface interface-number]
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC
Command History
Usage Guidelines Valid values for the port number depend on the chassis used.
Examples This example shows how to display the ACL configuration on interface fast 6/1:
Switch# show mac access-group interface fast 6/1
Interface FastEthernet6/1:
Inbound access-list is simple-mac-acl
Outbound access-list is not set
Related Commands access-group mode
interface (Optional) Specifies the interface type. Valid values are ethernet, fastethernet,
gigabitethernet, tengigabitethernet, pos, atm, port-channel, and ge-wan.
interface-number (Optional) Specifies the port number.
Release Modification
12.1(19)EW Support for this command was introduced on the Catalyst 4500 series switch.