2-215
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
qos cos
qos cos
To define the default CoS value for an interface, use the qos cos command. To remove a prior entry, use
the no form of this command.
qos cos cos_value
no qos cos cos_value
Syntax Description
Defaults The default CoS value is 0.
Note CoS override is not configured.
Command Modes Interface configuration
Command History
Usage Guidelines CoS values are configurable on physical LAN ports only.
Examples This example shows how to configure the default QoS CoS value as 6:
Switch(config-if)# qos cos 6
Switch(config-if)#
Related Commands show qos
cos_value Default CoS value for the interface; valid values are from 0 to 7.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
To Next Page
Loading...
