Cisco 4500M Command Reference

2-198
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
power inline
Examples This example shows how to set the inline-power detection and power for the inline-power-capable
interfaces:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface fastethernet 4/1
Switch(config-if)# power inline auto
Switch(config-if)# end
Switch#
This example shows how to disable the inline-power detection and power for the inline-power-capable
interfaces:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface fastethernet 4/1
Switch(config-if)# power inline never
Switch(config-if)# end
Switch#
This example shows how to set the permanent Power over Ethernet allocation to 8000 mW for Fast
Ethernet interface 4/1 regardless what is mandated either by the 802.3af class of the discovered device
or by any CDP packet that is received from the powered device:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface fastethernet 4/1
Switch(config-if)# power inline consumption 8000
Switch(config-if)# end
Switch#
Related Commands power inline consumption
show power

Cisco 4500M Specifications

General

Brand	Cisco
Model	4500M
Category	Network Router
Language	English