2-225
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
qos trust
Examples This example shows how to set the trusted state of an interface to CoS:
Switch(config-if)# qos trust cos
Switch(config-if)#
This example shows how to set the trusted state of an interface to DSCP:
Switch(config-if)# qos trust dscp
Switch(config-if)#
This example shows how to set the PVID CoS level to 6:
Switch(config-if)# qos trust extend cos 6
Switch(config-if)#
This example shows how to set the Cisco phone as the trust device:
Switch(config-if)# qos trust device cisco-phone
Switch(config-if)#
Related Commands qos cos
qos vlan-based
show qos interface