2-460
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
switchport access vlan
Note This command is not used on platforms that do not support Cisco-routed ports. All physical ports on such
platforms are assumed to be Layer 2-switched interfaces.
This example shows how to cause a port interface that has already been configured as a switched
interface to operate in VLAN 2 instead of the platform’s default VLAN when in access mode:
Switch(config-if)# switchport access vlan 2
Switch(config-if)#
Related Commands show interfaces switchport
To Next Page
Loading...
