Cisco 4500M - Page 555

Index
IN-7
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
controlling packet logging 2-121
enabling dynamic inspection 2-120
limit rate of incoming requests 2-113
set per-port config trust state 2-117
showing status of dynamic ARP inspection 2-295
showing status of log buffer 2-298
IPC
debugging IPC activities 2-52
IP DHCP Snooping
See DHCP snooping
IP header validation
disabling 2-154
enabling 2-154
IP multicast
displaying multicast routing table information 2-319
IP packets
enable DSCP rewrite 2-223
IP phone and standard desktop
enabling Cisco-recommended features 2-174
IP source binding
adding or deleting 2-151
displaying bindingstagging 2-324
IP source guard
debugging messages 2-55
displaying configuration and filters 2-325
enabling on DHCP snooping 2-155
J
Jumbo frames
enabling jumbo frames 2-186
L
l2protocol-tunnel cos command 2-158
LACP
deselecting channeling protocol 2-16
enabling LACP on an interface 2-16
setting channeling protocol 2-16
Layer 2
displaying ACL configuration 2-335
Layer 2 interface type
specifying a nontrunking, nontagged single VLAN
interface 2-462
specifying a trunking VLAN interface 2-462
Layer 2 protocol ports
displaying 2-329
Layer 2 protocol tunneling error recovery 2-160
Layer 2 switching
enabling voice VLANs 2-457
modifying switching characteristics 2-457
Layer 2 traceroute
IP addresses 2-481
Layer 3 switching
displaying port status 2-286
displaying status of native VLAN tagging 2-286
log buffer
show status 2-298
logging
ip arp inspection vlan command 2-121
M
MAC Access Control Lists
See MAC ACLs
MAC ACLs
defining extended MAC access list 2-163
displaying MAC ACL information 2-400
naming an ACL 2-163
MAC address filtering
configuring 2-170
disabling 2-170
enabling 2-170
MAC address table
adding static entries 2-180
clearing dynamic entries 2-36
configuring aging time 2-166