Cisco ASR 9901 Hardware Installation Guide

Figure 112: Removing or Installing an AC or DC Power Module (Cisco ASR 9001 AC power shown)
Installing an AC or DC Power Module
To install an AC or DC power module (see the above figure):
Procedure
Step 1 Slide the power module into the open bay until it mates with its backplane connector. Make sure that keying
lever locks with the chassis.
Step 2 Attach the power cabling to the power module.
Step 3 Verify that the OK (green) power indicator on the front of the power module comes ON. If the indicator does
not light up, see Troubleshooting the Power Subsystem, on page 103 section.
Removing a Chassis from the Equipment Rack
Use this procedure to remove the chassis and its components from the equipment rack:
You must use two people to remove the chassis from the equipment rack safely. An empty chassis can weigh
up to approximately 24.69 pounds (11.2 kg).
Caution
Cisco ASR 9901, ASR 9001, and ASR 9001-S Routers Hardware Installation Guide
139
Replacing Router Components
Installing an AC or DC Power Module

Cisco ASR 9901 Specifications

General

Brand	Cisco
Model	ASR 9901
Category	Network Router
Language	English