Cisco ASR 9901 Hardware Installation Guide

ValueParameter
12 VDCNominal
11.4 VDCMinimum
Power
Cisco ASR 9001—750 W
Cisco ASR 9901—1600
W
Minimum (one power module)
Cisco ASR 9001—1500
W
Cisco ASR 9901—3200
W
Maximum (two power modules)
RP Port Specifications
Table 26: RP Port Specifications
ValueDescription
EIA/TIA-232 RJ-45 interface, 115200 Baud, 8 data, no parity, 1 stop bit with
software handshake (default)
Console port
EIA/TIA-232 RJ-45 interface, 115200 Baud, 8 data, no parity, 1 stop bit with
software handshake (default)
Auxiliary port
Triple-speed (10M/100M/1000M) RJ-45Management ports (0, 1)
Can be configured as one of the following:
• BITS (Building Integrated Timing System) port
• J.211 or UTI (Universal Timing Interface) port
Sync ports (0, 1)
Power Consumption Specifications
The following table lists the power consumption specifications for a fully configured chassis.
Be sure that the chassis configuration complies with the required power budgets. Failure to properly verify
the configuration may result in an unpredictable state if one of the power units fails. Contact your local sales
representative for assistance.
Caution
Cisco ASR 9901, ASR 9001, and ASR 9001-S Routers Hardware Installation Guide
147
Technical Specifications
RP Port Specifications

Cisco ASR 9901 Specifications

General

Chassis Height	1 RU
Rack Mounting	Yes
Redundancy	Yes
Operating System	Cisco IOS XR
Switching Capacity	Up to 1.2 Tbps
Memory	16 GB
Power Supply	Dual redundant AC or DC
Interfaces	10GE, 100GE
Operating Temperature	0 to 40°C (32 to 104°F)
Input Voltage	100-240V AC
Power Consumption	Varies based on configuration
Storage	64 GB SSD
Humidity	5% to 95% (non-condensing)