ValueDescription
Operating (halfsine): 21 in/sec (0.53 m/sec)
Nonoperating (trapezoidal pulse): 20 G, 52 in/sec
(1.32 m/sec)
G is a value of acceleration, where 1G
equals 32.17 ft/sec2 (9.81 m/sec2).
Note
Shock
Operating: 0.35 Grms from 3 to 500 Hz
Grms is the root mean square value of
acceleration.
Note
Nonoperating: 1.0 Grms from 3 to 500 Hz
Vibration
AC Electrical Specifications
Be sure that the chassis configuration complies with the required power budgets. Failure to properly verify
the configuration may result in an unpredictable state if one of the power units fails. Contact your local sales
representative for assistance.
Caution
Cisco ASR 9901 AC Electrical Specifications
ValueDescription
Up to two AC power modules per systemPower modules per system
1633 VA (volt-amps) per AC power supply (up to two AC power supply
modules per system)
Total AC input power
100–240 VAC nominal (range: 90 to 264 VAC)
220–240 VAC (UK)
Rated input voltage
For each AC power
supply module.
Note
50/60 Hz nominal (range: 47 to 63 Hz)
50/60 Hz (UK)
Rated input line frequency
15 A maximum at 100 VAC
13 A maximum at 220 to 240 VRMS (UK)
Input current rating
15 A North America and Japan; 10 A international; 13 A UKSource AC service requirement
Power redundancy requirements vary, based on system configuration
(number and type of line cards, etc). AC powered systems are 1+1
protected.
Redundancy
Cisco ASR 9901, ASR 9001, and ASR 9001-S Routers Hardware Installation Guide
143
Technical Specifications
AC Electrical Specifications
To Next Page
Need help?
General
