Cisco ASR 9901 Hardware Installation Guide

Figure 88: Cisco ASR 9901 Router Cable Management Bracket
When shipped, the cable-management bracket is not attached to the router chassis. You must attach the
cable-management bracket to the chassis before you insert the cables into the ports.
Note
Installing a Cable Management Bracket
To install a cable-management bracket, follow these steps:
Procedure
Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 2 Position the cable management bracket over the center holes of the chassis rack mount brackets (see the
following figure).
Cisco ASR 9901, ASR 9001, and ASR 9001-S Routers Hardware Installation Guide
86
Installing Modules and Cables in the Chassis
Installing a Cable Management Bracket

Cisco ASR 9901 Specifications

General

Chassis Height	1 RU
Rack Mounting	Yes
Redundancy	Yes
Operating System	Cisco IOS XR
Switching Capacity	Up to 1.2 Tbps
Memory	16 GB
Power Supply	Dual redundant AC or DC
Interfaces	10GE, 100GE
Operating Temperature	0 to 40°C (32 to 104°F)
Input Voltage	100-240V AC
Power Consumption	Varies based on configuration
Storage	64 GB SSD
Humidity	5% to 95% (non-condensing)