Cisco Catalyst 6500 Series - Page 132

Index
IN-4
Catalyst 6500 Series Switch SIP, SSC, and SPA Hardware Installation Guide
OL-9041-04
(figure) 3-23
for OC-12c/STM-4 POS SPA 3-21, 3-22
SFP (small form-factor pluggable) optics
2-Port Gigabit Ethernet SPA 3-46
Cisco Systems qualification check 1-5
qualified for SPAs (table) 1-5
SFP-GE-L 3-51, 3-55, 3-56
SFP-GE-S 3-51, 3-55
SFP-GE-Z 3-48, 3-52, 3-55, 3-56
SFP module 3-50, 3-54
cabling 3-52, 3-56
SFP-OC12-IR1 3-22
SFP-OC12-LR1 3-22
SFP-OC12-MM 3-22
SFP-OC12-SR 3-22
SFP-OC3-LR2 3-22
SFP-OC48-IR1 3-27
SFP-OC48-LR2 3-27
SFP-OC48-SR 3-27
Shipment
Packing a SIP for 7-4
Packing a SPA for 7-3
short reach
SFP optical transceiver module 3-22
XFP optical transceiver module 3-27
short-reach
XFP optical transceiver module 3-33
show diagbus command 2-3
show hw-module slot command 2-3
show hw-module subslot command 2-4
show hw-module subslot oir command 5-6
show idprom module command 2-3, 2-4
show ip interface command 5-6
show module command 2-3, 5-3
show sip-disk command 2-3
simplex MTP connector
(figure) 3-38
SIP (SPA interface processor)
activation (example) 5-7
blank filler plates 1-1
chassis slot installation (figure) 2-3
deactivating 5-3
deactivation (example) 5-7
definition 1-1
general characteristics 1-1
reactivating 5-3
SPA compatiblity (table) 1-3, 1-4
subslots
description 1-1
numbering 2-4
specifying location in CLI 2-4
supervisor engine support 2-2
small form-factor pluggable
see XFP or SFP
SPA (shared port adapter)
activation (example) 5-8
Cable management brackets 6-7
chassis slot orientation (figure) 1-3
deactivating 5-4
deactivation (example) 5-8
definition 1-2
double-height description 1-2
heights supported
(figure) 1-2
description 1-2
interfaces 1-3
optics compatibility (table) 1-5
reactivating 5-5
single-height description 1-2
SIP compatibility (table) 1-3, 1-4
subslot numbering (figure) 2-3
SPA interface processors (SIPs) 2-1
SSC (SPA services card)
blank filler plates 1-2
definition 1-2
general characteristics 1-2
subslots
description 1-1