To Next Page

To Previous Page

3-10

Catalyst 6500 Series Content Switching Module Configuration Note

OL-4612-01

Chapter 3 Getting Started

Configuration Overview

To configure the required parameters, see the following sections:

• Configuring Client-Side VLANs, page 4-2

• Configuring Server-Side VLANs, page 4-3

• Configuring Server Farms, page 5-1

• Configuring Real Servers, page 5-2

• Configuring Virtual Servers, page 6-1

After you configure the required load-balancing parameters on the CSM, you can configure the optional

parameters in the following sections:

• Configuring Redirect Virtual Servers, page 6-5

• Configuring Client NAT Pools, page 5-5

• Configuring Server-Initiated Connections, page 5-6

• Configuring TCP Parameters, page 6-4

To work with advanced configurations, refer to the following sections in Chapter 2 through Chapter 11:

• Configuring the Single Subnet (Bridge) Mode, page 2-1

• Configuring the Secure (Router) Mode, page 2-4

• Configuring URL Hashing, page 5-6

• Configuring Generic Header Parsing, page 6-12

• Configuring Route Health Injection, page 8-2

• Configuring Fault Tolerance, page 7-1

• Configuring Persistent Connections, page 8-8

• Configuring HSRP, page 7-5

• Configuring Connection Redundancy, page 7-8

• Configuring SNMP Traps for Real Servers, page 8-13

• Configuring Probes for Health Monitoring, page 9-1

• Configuring Inband Health Monitoring, page 9-7

• Configuring HTTP Return Code Checking, page 9-8

• Configuring TCL Scripts, page 10-1

• Configuring Stealth Firewall Load Balancing, page 11-7

• Configuring Regular Firewall Load Balancing, page 11-16

• Configuring Reverse-Sticky for Firewalls, page 11-24

Cisco Catalyst 6500 Series Configuration Note

Other manuals for Cisco Catalyst 6500 Series