CHAPTER
8-1
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
8
Configuring SDM Templates
This chapter describes how to configure the Switch Database Management (SDM) templates on the
IE
3000 switch.
Note For complete syntax and usage information for the commands used in this chapter, see the command
reference for this release.
This chapter consists of these sections:
• Understanding the SDM Templates, page 8-1
• Configuring the Switch SDM Template, page 8-2
• .Displaying the SDM Templates, page 8-3
Understanding the SDM Templates
You can use SDM templates to configure system resources in the switch to optimize support for specific
features, depending on how the switch is used in the network. You can select a template to provide
maximum system usage for some functions or use the default template to balance resources.
To allocate ternary content addressable memory (TCAM) resources for different usages, the switch SDM
templates prioritize system resources to optimize support for certain features. You can select SDM
templates to optimize these features:
• Default—The default template gives balance to all functions.
• QoS—The QoS template maximizes system resources for quality of service (QoS) access control
entries (ACEs).
Ta b l e 8-1 Approximate Number of Feature Resources Allowed by Each Template
Resource Default QoS
Unicast MAC addresses 8 K 8 K
IPv4 IGMP groups 256 256
IPv4 unicast routes 0 0
IPv4 policy-based routing aces 0 0
IPv4 MAC QoS ACEs 128 384
IPv4 MAC security ACEs 384 128
To Next Page
Loading...
Need help?
General
