Cisco IE 3000 - Disabling and Enabling LLDP on an Interface

23-5
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
Chapter 23 Configuring LLDP and LLDP-MED
Configuring LLDP and LLDP-MED
Beginning in privileged EXEC mode, follow these steps to enable LLDP-MED when it has been
disabled:
This example shows how to globally disable LLDP.
Switch# configure terminal
Switch(config)# no lldp run
Switch(config)# end
This example shows how to globally enable LLDP.
Switch# configure terminal
Switch(config)# lldp run
Switch(config)# end
Disabling and Enabling LLDP on an Interface
LLDP is disabled by default on all supported interfaces to send and to receive LLDP information.
Note If the interface is configured as a tunnel port, LLDP is automatically disabled.
Beginning in privileged EXEC mode, follow these steps to disable LLDP on an interface.
Step 2
no lldp run Disable LLDP.
Step 3
end Return to privileged EXEC mode.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
lldp run Enable LLDP.
Step 3
end Return to privileged EXEC mode.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface-id Specify the interface on which you are disabling LLDP, and enter
interface configuration mode.
Step 3
no lldp transmit No LLDP packets are sent on the interface.
Step 4
no lldp receive No LLDP packets are received on the interface.
Step 5
end Return to privileged EXEC mode.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.