28-4
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
Chapter 28 Configuring System Message Logging
Configuring System Message Logging
Disabling Message Logging
Message logging is enabled by default. It must be enabled to send messages to any destination other than
the console. When enabled, log messages are sent to a logging process, which logs messages to
designated locations asynchronously to the processes that generated the messages.
Beginning in privileged EXEC mode, follow these steps to disable message logging. This procedure is
optional.
Disabling the logging process can slow down the switch because a process must wait until the messages
are written to the console before continuing. When the logging process is disabled, messages appear on
the console as soon as they are produced, often appearing in the middle of command output.
The logging synchronous global configuration command also affects the display of messages to the
console. When this command is enabled, messages appear only after you press Return. For more
information, see the
“Synchronizing Log Messages” section on page 28-6.
To re-enable message logging after it has been disabled, use the logging on global configuration
command.
Time stamps Disabled.
Synchronous logging Disabled.
Logging server Disabled.
Syslog server IP address None configured.
Configuration change logger Disabled
Server facility Local7 (see Table 28-4 on page 28-13).
Server severity Informational (and numerically lower levels; see
Table 28-3 on page 28-9).
Table 28-2 Default System Message Logging Configuration (continued)
Feature Default Setting
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
no logging console Disable message logging.
Step 3
end Return to privileged EXEC mode.
Step 4
show running-config
or
show logging
Verify your entries.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration file.
To Next Page
Loading...
Need help?
General
