23-3
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
Chapter 23 Configuring LLDP and LLDP-MED
Configuring LLDP and LLDP-MED
• Location TLV
Provides location information from the switch to the endpoint device. The location TLV can send
this information:
–
Civic location information
Provides the civic address information and postal information. Examples of civic location
information are street address, road name, and postal community name information.
–
ELIN location information
Provides the location information of a caller. The location is determined by the Emergency
location identifier number (ELIN), which is a phone number that routes an emergency call to
the local public safety answering point (PSAP) and which the PSAP can use to call back the
emergency caller.
Configuring LLDP and LLDP-MED
This section contains this configuration information:
• Default LLDP Configuration, page 23-3
• Configuring LLDP Characteristics, page 23-4
• Disabling and Enabling LLDP Globally, page 23-4
• Disabling and Enabling LLDP on an Interface, page 23-5
• Configuring LLDP-MED TLVs, page 23-6
Default LLDP Configuration
Table 23-1 shows the default LLDP configuration. To change the default settings, use the LLDP global
configuration and LLDP interface configuration commands.
Ta b l e 23-1 Default LLDP Configuration
Feature Default Setting
LLDP global state Disabled
LLDP holdtime (before discarding) 120 seconds
LLDP timer (packet update frequency) 30 seconds
LLDP reinitialization delay 2 seconds
LLDP tlv-select Disabled to send and receive all TLVs.
LLDP interface state Disabled
LLDP receive Disabled
LLDP transmit Disabled
LLDP med-tlv-select Disabled to send all LLDP-MED TLVs
To Next Page
Loading...
Need help?
General
