27-6
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
Chapter 27 Configuring RMON
Displaying RMON Status
To disable the collection of group Ethernet statistics, use the no rmon collection stats index interface
configuration command.
This example shows how to collect RMON statistics for the owner root:
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# rmon collection stats 2 owner root
Displaying RMON Status
To display the RMON status, use one or more of the privileged EXEC commands in Table 27-1:
For information about the fields in these displays, see the “System Management Commands” section in
the Cisco IOS Configuration Fundamentals Command Reference, Release
12.2 from the Cisco.com page
under Documentation > Cisco IOS Software > 12.2 Mainline > Command References.
Step 3
rmon collection stats index [owner ownername] Enable RMON statistic collection on the interface.
• For index, specify the RMON group of statistics. The range
is from 1 to 65535.
• (Optional) For owner ownername, enter the name of the
owner of the RMON group of statistics.
Step 4
end Return to privileged EXEC mode.
Step 5
show running-config Verify your entries.
Step 6
show rmon statistics Display the contents of the switch statistics table.
Step 7
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Ta b l e 27-1 Commands for Displaying RMON Status
Command Purpose
show rmon Displays general RMON statistics.
show rmon alarms Displays the RMON alarm table.
show rmon events Displays the RMON event table.
show rmon history Displays the RMON history table.
show rmon statistics Displays the RMON statistics table.
To Next Page
Loading...
Need help?
General
