Cisco IE 3000 User Manual

11-19
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
Chapter 11 Configuring Interface Characteristics
Monitoring and Maintaining the Interfaces
Monitoring and Maintaining the Interfaces
These sections contain interface monitoring and maintenance information:
• Monitoring Interface Status, page 11-19
• Clearing and Resetting Interfaces and Counters, page 11-20
• Shutting Down and Restarting the Interface, page 11-20
Monitoring Interface Status
Commands entered at the privileged EXEC prompt display information about the interface, including
the versions of the software and the hardware, the configuration, and statistics about the interfaces.
Table 11-4 lists some of these interface monitoring commands. (You can display the full list of show
commands by using the show ? command at the privileged EXEC prompt.) These commands are fully
described in the Cisco IOS Interface Command Reference, Release 12.2 from the Cisco.com page under
Documentation > Cisco IOS Software > 12.2 Mainline > Command References.
Ta b l e 11-4 Show Commands for Interfaces
Command Purpose
show interfaces [interface-id] (Optional) Display the status and configuration of all interfaces or a
specific interface.
show interfaces interface-id status [err-disabled] (Optional) Display interface status or a list of interfaces in an
error-disabled state.
show interfaces [interface-id] switchport (Optional) Display administrative and operational status of switching
ports.
show interfaces [interface-id] description (Optional) Display the description configured on an interface or all
interfaces and the interface status.
show ip interface [interface-id] (Optional) Display the usability status of all interfaces configured for
IP routing or the specified interface.
show interface [interface-id] stats (Optional) Display the input and output packets by the switching path
for the interface.
show interfaces transceiver properties (Optional) Display speed and duplex settings on the interface.
show interfaces [interface-id] [{transceiver
properties | detail}] module number]
Display physical and operational status about an SFP module.
show running-config interface [interface-id] Display the running configuration in RAM for the interface.
show version Display the hardware configuration, software version, the names and
sources of configuration files, and the boot images.
show controllers ethernet-controller interface-id
phy
Display the operational state of the auto-MDIX feature on the
interface.

Cisco IE 3000 Specifications

General

Operating Temperature	-40 to 75°C (-40 to 167°F)
DRAM	128 MB
Flash Memory	32 MB
Uplink Ports	2 x 10/100/1000Base-T or SFP
MAC Address Table Size	8000
Mounting	DIN rail, Wall