10-42
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
Chapter 10 Configuring IEEE 802.1x Port-Based Authentication
Displaying IEEE 802.1x Statistics and Status
To configure the port as an IEEE 802.1x port access entity (PAE) authenticator, which enables
IEEE
802.1x on the port but does not allow clients connected to the port to be authorized, use the dot1x
pae authenticator interface configuration command.
This example shows how to disable IEEE 802.1x authentication on the port:
Switch(config)# interface gigabitethernet1/2
Switch(config-if)# no dot1x pae authenticator
Resetting the IEEE 802.1x Authentication Configuration to the Default Values
Beginning in privileged EXEC mode, follow these steps to reset the IEEE 802.1x authentication
configuration to the default values. This procedure is optional.
Displaying IEEE 802.1x Statistics and Status
To display IEEE 802.1x statistics for all ports, use the show dot1x all statistics privileged EXEC
command. To display IEEE 802.1x statistics for a specific port, use the show dot1x statistics interface
interface-id privileged EXEC command.
To display the IEEE 802.1x administrative and operational status for the switch, use the show dot1x all
[details | statistics | summary] privileged EXEC command. To display the IEEE 802.1x administrative
and operational status for a specific port, use the show dot1x interface interface-id privileged EXEC
command.
For detailed information about the fields in these displays, see the command reference for this release.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface-id Enter interface configuration mode, and specify the port to be configured.
Step 3
dot1x default Reset the IEEE 802.1x parameters to the default values.
Step 4
end Return to privileged EXEC mode.
Step 5
show dot1x interface interface-id Verify your entries.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
To Next Page
Loading...
Need help?
General