Cisco IE 3000 User Manual

24-3
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
Chapter 24 Configuring CDP
Configuring CDP
Use the no form of the CDP commands to return to the default settings.
This example shows how to configure CDP characteristics.
Switch# configure terminal
Switch(config)# cdp timer 50
Switch(config)# cdp holdtime 120
Switch(config)# cdp advertise-v2
Switch(config)# end
For additional CDP show commands, see the “Monitoring and Maintaining CDP” section on page 24-4.
Disabling and Enabling CDP
CDP is enabled by default.
Note Switch clusters and other Cisco devices (such as Cisco IP Phones) regularly exchange CDP messages.
Disabling CDP can interrupt cluster discovery and device connectivity. For more information, see
Chapter 6, “Clustering Switches” and see Getting Started with Cisco Network Assistant, available on
Cisco.com.
Beginning in privileged EXEC mode, follow these steps to disable the CDP device discovery capability:
Beginning in privileged EXEC mode, follow these steps to enable CDP when it has been disabled:
This example shows how to enable CDP if it has been disabled.
Switch# configure terminal
Switch(config)# cdp run
Switch(config)# end
Step 6
show cdp Verify your settings.
Step 7
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
no cdp run Disable CDP.
Step 3
end Return to privileged EXEC mode.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
cdp run Enable CDP after disabling it.
Step 3
end Return to privileged EXEC mode.

Cisco IE 3000 Specifications

General

Brand	Cisco
Model	IE 3000
Category	Switch
Language	English