Cisco IE 3000 - Using FTP to Access the MIB Files

A-3
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
Appendix A Supported MIBs
Using FTP to Access the MIB Files
• SNMP-TARGET-MIB
• SNMPv2-MIB
• TCP-MIB
• UDP-MIB
Note You can also use this URL for a list of supported MIBs for the IE3000 switch:
ftp://ftp.cisco.com/pub/mibs/supportlists/ie3000/ie3000-supportlist.html
You can access other information about MIBs and Cisco products on the Cisco web site:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
Using FTP to Access the MIB Files
You can get each MIB file by using this procedure:
Step 1 Make sure that your FTP client is in passive mode.
Note Some FTP clients do not support passive mode.
Step 2 Use FTP to access the server ftp.cisco.com.
Step 3 Log in with the username anonymous.
Step 4 Enter your e-mail username when prompted for the password.
Step 5 At the ftp> prompt, change directories to /pub/mibs/v1 and /pub/mibs/v2.
Step 6 Use the get MIB_filename command to obtain a copy of the MIB file.