Cisco Nexus 3548 series - Configuring SNMP Notification Receivers

• Source port
• Destination port
• Protocol (UDP or TCP)
The ACL applies to both IPv4 and IPv6 over UDP and TCP. After creating the ACL, assign the ACL to the
SNMP community.
For more information about creating ACLs, see the NX-OS security configuration guide for the Cisco Nexus
Series software that you are using.
Tip
Use the following command in global configuration mode to assign an IPv4 or IPv6 ACL to an SNMPv3
community to filter SNMP requests:
PurposeCommand
Assigns an IPv4 or IPv6 ACL to an SNMPv3
community to filter SNMP requests.
switch(config)# snmp-server community name [use-ipv4acl
ipv4acl-name] [use-ipv6acl ipv6acl-name]
switch(config)# snmp-server community public
use-ipv4acl myacl
Configuring SNMP Notification Receivers
You can configure Cisco NX-OS to generate SNMP notifications to multiple host receivers.
You can configure a host receiver for SNMPv1 traps in a global configuration mode.
PurposeCommand
Configures a host receiver for SNMPv1 traps. The ip-address
can be an IPv4 or IPv6 address. The community can be any
alphanumeric string up to 255 characters. The UDP port number
range is from 0 to 65535.
switch(config)# snmp-server host
ip-address traps version 1 community
[udp_port number]
You can configure a host receiver for SNMPv2c traps or informs in a global configuration mode.
PurposeCommand
Configures a host receiver for SNMPv2c traps or informs. The
ip-address can be an IPv4 or IPv6 address. The community
can be any alphanumeric string up to 255 characters. The UDP
port number range is from 0 to 65535.
switch(config)# snmp-server host
ip-address {traps | informs} version 2c
community [udp_port number]
You can configure a host receiver for SNMPv3 traps or informs in a global configuration mode.
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
98
Configuring SNMP
Configuring SNMP Notification Receivers