Cisco Nexus 3548 series - Default Settings for System Message Logging; Configuring System Message Logging

Table 6: Default System Message Logging Parameters
DefaultParameters
Enabled at severity level 2Console logging
Enabled at severity level 2Monitor logging
Enabled to log messages at severity level
5
Log file logging
Enabled at severity level 5Module logging
EnabledFacility logging
SecondsTime-stamp units
DisabledSyslog server logging
DisabledSyslog server configuration distribution
Configuring System Message Logging
Configuring System Message Logging to Terminal Sessions
You can configure the switch to log messages by their severity level to console, Telnet, and Secure Shell
sessions.
By default, logging is enabled for terminal sessions.
Procedure
PurposeCommand or Action
Copies syslog messages from the console to the
current terminal session.
switch# terminal monitor
Step 1
Enters global configuration mode.switch# configure terminal
Step 2
Enables the switch to log messages to the
console session based on a specified severity
switch(config)# logging console [severity-level]
Step 3
level or higher (a lower number value indicates
a higher severity level). Severity levels range
from 0 to 7:
• 0 – emergency
• 1 – alert
• 2 – critical
• 3 – error
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
37
Configuring System Message Logging
Configuring System Message Logging