Executed CommandsDescriptionAlert Group
show module
show version
show license usage
show inventory
show sprom all
show system uptime
Inventory status that is provided
whenever a unit is cold booted, or when
FRUs are inserted or removed. This alert
is considered a noncritical event, and the
information is used for status and
entitlement.
Inventory
Smart Call Home maps the syslog severity level to the corresponding Smart Call Home severity level for
syslog port group messages.
You can customize predefined alert groups to execute additional show commands when specific events occur
and send that show output with the Smart Call Home message.
You can add show commands only to full text and XML destination profiles. Short text destination profiles
do not support additional show commands because they only allow 128 bytes of text.
Smart Call Home Message Levels
Smart Call Home allows you to filter messages based on their level of urgency. You can associate each
destination profile (predefined and user defined) with a Smart Call Home message level threshold. The switch
does not generate any Smart Call Home messages with a value lower than this threshold for the destination
profile. The Smart Call Home message level ranges from 0 (lowest level of urgency) to 9 (highest level of
urgency), and the default is 0 (the switch sends all messages).
Smart Call Home messages that are sent for syslog alert groups have the syslog severity level mapped to the
Smart Call Home message level.
Smart Call Home does not change the syslog message level in the message text.
Note
The following table shows each Smart Call Home message level keyword and the corresponding syslog level
for the syslog port alert group.
Table 9: Severity and Syslog Level Mapping
DescriptionSyslog LevelKeywordSmart Call Home
Level
Network-wide catastrophic failure.N/ACatastrophic9
Significant network impact.N/ADisaster8
System is unusable.Emergency (0)Fatal7
Critical conditions that indicate that immediate attention
is needed.
Alert (1)Critical6
Major conditions.Critical (2)Major5
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
54
Configuring Smart Call Home
Smart Call Home Message Levels
To Next Page
Loading...
