PurposeCommand or Action
Configures the switch priority for this switch.(Optional) switch(config-callhome)#
switch-priority number
Step 10
The range is from 0 to 7, with 0 being the
highest priority and 7 the lowest. The default
is 7.
Switch priority is used by the
operations personnel or TAC
support personnel to decide which
Call Home message should be
responded to first. You can
prioritize Call Home alerts of the
same severity from each switch.
Note
Displays a summary of the Smart Call Home
configuration.
(Optional) switch# show callhome
Step 11
Saves the change persistently through reboots
and restarts by copying the running
configuration to the startup configuration.
(Optional) switch(config)# copy
running-config startup-config
Step 12
Example
The following example shows how to configure the contact information for Call Home:
switch# configuration terminal
switch(config)# snmp-server contact personname@companyname.com
switch(config)# callhome
switch(config-callhome)# email-contact personname@companyname.com
switch(config-callhome)# phone-contact +1-800-123-4567
switch(config-callhome)# street-address 123 Anystreet St., Anycity, Anywhere
What to do next
Create a destination profile.
Creating a Destination Profile
You must create a user-defined destination profile and configure the message format for that new destination
profile.
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Enters Smart Call Home configuration mode.switch(config)# callhome
Step 2
Creates a new destination profile and sets the
message format for the profile. The
switch(config-callhome)# destination-profile
{ciscoTAC-1 {alert-group group | email-addr
Step 3
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
62
Configuring Smart Call Home
Creating a Destination Profile
To Next Page
Loading...
