Cisco Nexus 3548 series - Page 75

Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Configures the SNMP sysContact.switch(config)# snmp-server contact
sys-contact
Step 2
Enters Smart Call Home configuration mode.switch(config)# callhome
Step 3
Configures the e-mail address for the primary
person responsible for the switch.
switch(config-callhome)# email-contact
email-address
Step 4
The email-address can be up to 255
alphanumeric characters in an e-mail address
format.
You can use any valid e-mail
address. The address cannot contain
spaces.
Note
Configures the phone number in international
phone number format for the primary person
switch(config-callhome)# phone-contact
international-phone-number
Step 5
responsible for the device. The
international-phone-number can be up to 17
alphanumeric characters and must be in
international phone number format.
The phone number cannot contain
spaces. Use the plus (+) prefix
before the number.
Note
Configures the street address for the primary
person responsible for the switch.
switch(config-callhome)# streetaddress
address
Step 6
The address can be up to 255 alphanumeric
characters. Spaces are accepted.
Configures the contract number for this switch
from the service agreement.
(Optional) switch(config-callhome)#
contract-id contract-number
Step 7
The contract-number can be up to 255
alphanumeric characters.
Configures the customer number for this
switch from the service agreement.
(Optional) switch(config-callhome)#
customer-id customer-number
Step 8
The customer-number can be up to 255
alphanumeric characters.
Configures the site number for this switch.(Optional) switch(config-callhome)# site-id
site-number
Step 9
The site-number can be up to 255
alphanumeric characters in free format.
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
61
Configuring Smart Call Home
Configuring Contact Information