PurposeCommand or Action
activated. (Skip this step if the package was
activated earlier with the install add activate
command.)
switch# install activate
n3500-uk9.6.0.2.U6.0.1.CSCab00001.bin
Example:
switch# install activate
n3500-uk9.6.0.2.U6.0.1.CSCab00001.bin
Press ? after a partial package name
to display all possible matches
available for activation. If there is
only one match, press the Tab key
to fill in the rest of the package
name.
Note
Install operation 1 completed
successfully at
Thu Jan 9 01:27:56 2014
Example:
switch# install activate
n3500-uk9.6.0.2.U6.0.1.CSCab00001.bin
Install operation 2 !!WARNING!! This
patch will get
activated only after a reload of the
switch. at
Sun Mar 9 00:42:12 2014
Activates additional packages as required.Repeat Step 3 until all packages are activated.
Step 4
Displays all active packages. Use this command
to determine if the correct packages are active.
(Optional) show install active
Example:
Step 5
switch# show install active
Committing the Active Package Set
When an SMU package is activated on the device, it becomes part of the current running configuration. To
make the package activation persistent across system-wide reloads, you must commit the package on the
device.
Procedure
PurposeCommand or Action
Commits the current set of packages so that
these packages are used if the device is
restarted.
install commit filename
Example:
switch# install commit
n3500-uk9.6.0.2.U6.0.1.CSCab00001.bin
Step 1
Displays which packages are committed.(Optional) show install committed
Example:
Step 2
switch# show install committed
Deactivating and Removing Packages
When a package is deactivated, it is no longer active on the device, but the package files remain on the boot
disk. The package files can be reactivated later, or they can be removed from the disk.
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
194
Performing Software Maintenance Upgrades (SMUs)
Committing the Active Package Set
To Next Page
Loading...
