Cisco Nexus 3548 series - Additional References

Configuration Example for an ERSPAN Destination Session
The following example shows how to configure an ERSPAN destination session:
switch# config t
switch(config)# interface e14/29
switch(config-if)# no shut
switch(config-if)# switchport
switch(config-if)# switchport monitor
switch(config-if)# exit
switch(config)# monitor session 2 type erspan-destination
switch(config-erspan-dst)# source ip 9.1.1.2
switch(config-erspan-dst)# destination interface e14/29
switch(config-erspan-src)# erspan-id 1
switch(config-erspan-dst)# no shut
switch(config-erspan-dst)# exit
switch(config)# show monitor session 2
Additional References
Related Documents
Document TitleRelated Topic
Cisco Nexus NX-OS System Management Command
Reference for your platform.
ERSPAN commands: complete command syntax,
command modes, command history, defaults, usage
guidelines, and examples
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
165
Configuring ERSPAN
Configuration Example for an ERSPAN Destination Session