PurposeCommand or Action
Sends a test message to all configured
destinations.
switch(config-callhome) # callhome test
Step 4
Saves the change persistently through reboots
and restarts by copying the running
configuration to the startup configuration.
(Optional) switch(config)# copy
running-config startup-config
Step 5
Example
The following example shows how to enable Smart Call Home:
switch# configuration terminal
switch(config)# callhome
switch(config-callhome)# callhome send diagnostic
switch(config-callhome)# callhome test
switch(config-callhome)#
Verifying the Smart Call Home Configuration
Use one of the following commands to verify the configuration:
PurposeCommand
Displays the status for Smart Call Home.show callhome
Displays one or more Smart Call Home destination profiles.
show callhome destination-profile name
Displays the differences between he pending and running
Smart Call Home configuration.
show callhome pending-diff
Displays the Smart Call Home status.show callhome status
Displays the e-mail configuration for Smart Call Home.show callhome transport-email
Displays CLI commands added to any alert groups.show callhome user-def-cmds
Displays the running configuration for Smart Call Home.show running-config [callhome |
callhome-all]
Displays the startup configuration for Smart Call Home.show startup-config callhome
Displays the technical support output for Smart Call Home.show tech-support callhome
Sample Syslog Alert Notification in Full-Text Format
This sample shows the full-text format for a syslog port alert-group notification:
source:MDS9000
Switch Priority:7
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
70
Configuring Smart Call Home
Verifying the Smart Call Home Configuration
To Next Page
Loading...
